GeekMacDaddy

Geek-Screamer

This hand wired and soldered Screamer uses only high end components including a top quality op-amp with better breakup, 1% metal film resistors which allow less noise and noticeably better low end response. Toggle between the Screamerís stock and bass boost signal. The Geek Screamer uses top-of-the-line Wima, AVX and Nichicon capacitors, Alpha Pots knobs, Neutrik and Switchcraft jacks. And of course True Bypass. The Geek Screamerís unique graphics are sure to get noticed and make it the must-have pedal of the year.
  • Hand wired and soldered.
  • High-end Op-amp.
  • Bass boost toggle switch.
  • 1% metal film resistors allow less noise and better low end response.
  • Wima, AVX and Nichicon capacitors.
  • Alpha Pots.
  • Neutrik and Switchcraft Jacks.
  • Powder coated enclosures.
  • True Bypass switch.

Geek Ranger

This high-end hand made pedal instantly delivers 60ís and 70ís vintage tone. The GeekRanger is not an overdrive but rather a frequency booster which causes earlier pre-amp and speaker breakup. The Ranger uses the same basic circuitry (with some Geek modifications) as the Dallas Rangemaster which was made famous by players like Brian May, Tony Iommi and Richie Blackmore.
  • Hand wired and soldered.
  • True Bypass
  • Full Range toggle switch.
  • 1% metal film resistors (most are RN55Dís) allow less noise and better low end response.
  • Wima, AVX and Nichicon capacitors.
  • Alpha Pots.
  • Neutrik and Switchcraft Jacks.
  • Powder coated enclosures.

British Ball Breaker

Like all of our pedals, the BBB is hand wired hand soldered, and built from scratch, from the ground up. As of now, we are using very high quality Burr Brown OPA2134 opamps, contributing to the incredible sound of this pedal, and of course all of the top shelf brands and types of components found in our other pedals. The BBB captures that British sound, in a way that will fool you into thinking you aren't using a pedal at all. The first comments are in at The Gear Page, and are nothing less than stunning!

http://www.thegearpage.net/board/showthread.php?p=4409318#post4409318
http://www.thegearpage.net/board/showthread.php?t=414931

Looks like the Geek out-did himself on this one!
  • Hand wired and soldered.
  • Burr Brown 2134 opamp.
  • Volume, Tone, Presence, and Gain knobs.
  • 1% Precision Metal Film Resistors.
  • Wima, AVX and Nichicon capacitors.
  • Alpha Pots.
  • Neutrik and Switchcraft Jacks.
  • Powder coated enclosures.
  • True Bypass switch.

British Ball Breaker

Copyright 2008. All Rights Reserved.